Genie Community Forum

No audio output on RPi client

User Support
#1

Hello,

Sorry because I’m sure I’m going to miss a ton of basic info here. I’m running the Genie-Edge addon in Home Assistant (version 2.0.1). This is running in a Linux VM on my home server. I’ve got genie client v0.1.0 installed on a RPi with a USB mic and 3.5mm speaker. It’s connected to the server and takes commands. However, there is no audio response. You can see in the console output that it generates a reply but nothing is heard. I’ve checked the raspi-config tool to make sure the 3.5mm is the default. I’m not really sure where else to check,

#2

Hi, did you saw this page?

https://wiki.genie.stanford.edu/en/getting-started/installation-guide/raspberry-pi-speaker

first, for the “Additional configuration” part, where told how to set alsa mixer: " Use alsamixer -D hw:1 to set the volume of the “Headphone” to a non-zero value."

second, for the “Configuration” section so that al the modules and other stuff is correctly installed and loaded